[RESOLVED] Unable to run vic-20 Games

Hi All!!!!

I'm trying to configure vic-20 emulator on Gameex and can't get it work well.

I used the Greatflash tutorial:

 

 

Vice Commodore Vic20 Emulator Zip Setup
--------------------------------------------------

This Config allows you to run commodore Vic20 roms that are zipped.

You may ask, why would i want to run them as zips when they are so small already? The main reason is that a lot of the good vic20 rom sets are already zipped and tidy. I used GameBaseVic20, Tosec, and No-intro sets to check this config.
Second thing that this config tries to do is to determine what memory banks need to be active to run the game image. If you have a unexpanded 3k game and try to run it on a vic20 with 24k of expanded - it will not run. same rule applies for many different sizes. I have checked over 200 images and all runs fine. I have not checked cartridges fully, but it should recognise what memory area the cart needs to load into and run (unless the cartridge needs a SYS call to run it - then it is time for you to type on the Vic)
This works the same way as my c64 config.
so... Place the contents of 'VIC.RAR' in your Vice emulators root directory and import the emu config in 'Vic20EmConfig.RAR' remembering to change your paths.
Set Xvic.exe to how you wish (it will auto to fullscreen) and run the wonderful GameEx.

Hope all goes well...

If there are any probs or suggestions, please open a thread and i will see what i can do..

UPDATE: Vic.rar updated. Found problems with a couple of carts not running. Fixed and carts now load to correct memory space. All tested work!

When i launch a game it returns to Gameex automatically.... 

Any suggestions?

Thanks in advance.